Acquisition Basic Training – 3D Testing

Participants learn the fundamentals of digital image correlation and how to measure motion and deformation of dynamic part specimens using a stereo camera system. They learn both how to deal with reference point markers and stochastic patterns. With the support of the GOM trainer, the participants carry out practical exercises with the ARAMIS system and get a feel for the diverse fields of application.

Target GroupGOM beginners
SystemARAMIS sensor
ARAMIS Professional software
PrerequisitesBasic knowledge of deformation analysis
Basic PC skills (windows-based programs and operating systems)
Duration1 day
CertificateAcquisition Basic Training – 3D Testing
after completion of the training

GOM Training Center

Find the complete offer of all classroom training courses in your country.
Enroll in eLearning courses to learn at your own pace at any time and in any place in the world.

Create your personal account to view your completed courses, achievements and certificates as well as the presentations and demo data for your training courses.


Course content

  • Introduction to the ARAMIS sensor and software
  • Sensor handling
  • Hardware setup and calibration
  • Preparing measuring objects
  • Simple measurements
  • Defining and combining measuring procedures

GOM GmbH, Schmitzstraße 2

  • May 18, 2020 (Week 21)
  • June 08, 2020 (Week 24)
  • June 29, 2020 (Week 27) - fully booked
  • August 17, 2020 (Week 34)
  • September 07, 2020 (Week 37)

Additional dates on request.


GOM Süd, Wilhelm-Röntgen-Straße 11

  • June 27, 2020 (Week 31)
  • September 21, 2020 (Week 39)

Additional dates on request.



Learning Concept

GOM training courses follow a standardized concept, which was developed in cooperation with customers and partners from all over the world. The immediate vicinity to GOM’s development facilities guarantees a high standard of training contents and a direct link to practice.