Automation VMR

In the two-day training course, participants carry out the entire measuring procedure in the VMR and create a complete measurement program offline that is subsequently run in the ATOS ScanBox.

The Virtual Measuring Room (VMR) is a control and measurement planning software consisting of a virtual and functional representation of the real measuring environment. With appropriate licensing, the VMR is already included in the software.

After a comprehensive introduction to the VMR, participants learn how to position the measuring setup reproducibly. The inspection planning imparts the functional principle of the automatic position generation. Based on the imported measurement plan and CAD data, participants learn how to create ATOS measurement positions and photogrammetry measurement positions along with the corresponding robot paths automatically.

While the measurement series are executed, the so-called burn-in process takes place. This means that the software automatically defines and saves the individual measurement parameters for each measurement, such as the exposure time or reflection detection.

The participants complete the measuring project by creating a project template and gain insight into the Kiosk Interface, a special user interface for simplified operation of the ATOS ScanBox that can be used for component testing in series production.

  • Operation of the virtual measuring room
  • Reproducible simulation of the real measuring setup in the virtual measuring room
  • Fully automatic teaching of the robot
  • Automated measurement planning
  • Real movements and measurements in the VMR
  • Virtual positioning of the CAD model
  • Using the ATOS sensor in combination with the photogrammetry camera in the VMR
  • Measuring the top and bottom side of a measuring object
  • Working with and without fixtures
  • Working with project templates

Braunschweig
GOM GmbH,
Schmitzstraße 2

  • October 11 - October 12, 2018 (Week 41) - fully booked
  • October 25 - October 26, 2018 (Week 43) - fully booked
  • November 01 - November 02, 2018 (Week  44)
  • November 22 - November 23, 2018 (Week 47)
  • December 13 - December 14, 2018 (Week 50)

Additional dates on request.

 

Göppingen
topometric GmbH, Wilhelm-Zwick-Straße 7

  • September 27 - September 28, 2018 (Week 39)
  • October 11 - October 12, 2018 (Week 41) - fully booked
  • October 25 - October 26, 2018 (Week 43)
  • November 29 - November 30, 2018 (Week 48)
  • December 13 - December 14, 2018 (Week 50)

Additional dates on request.

Brazil

On request

Czech Republic

On request

France

On request

Japan

On request

Mexico

On request

United Kingdom

On request

USA

On request

Duration: 2 days
Number of participants: 3–6
Certificate: Automation VMR

Target group: GOM advanced users
System:

Prerequisites: