GD&T Training in April and June

03/2016GOM offers GD&T training courses in April, 12-13 and in June, 7-8 in Braunschweig (Germany). Participants will learn basic principles of the geometrical product specification and its implementation in the GOM software.

During the two-day training course, participants will gain a comprehensive insight into the theoretical basics and characteristics of GD&T. The subsequent practical section provides direct implementation of the acquired knowledge.

In addition, the following topics will be discussed:

  • Introduction to GD&T and GD&T basic standards
  • Tolerance concepts
  • Geometrical specifications
  • Sizes according to ISO 14405-1/2/3
  • Introduction to tolerance zones
  • Concepts and rules according to ISO 1101
  • Datums and datum systems
  • Geometric Dimensioning and Tolerancing (GD&T)
  • Maximum material condition
  • Combined features
  • Applications in GOM Inspect
  • Principles according to ISO 8015
  • Measurement uncertainty

Due to the limited number of participants, we recommend to register as soon as possible. A registration form and further information are available at the GOM Training page.